Hello, I am attempting to create a simple program opening up a serial port on the Sabrelight. Attached is the source code and below is the console output. On other sel4 blogs with this problem uboot may have been the issue. I have used the u-boot as discribed on the supported hardware->sabrelight page with the same outcome. Any help would be appreciated. Thanks, U-Boot 2009.08-dirty (Sep 17 2015 - 14:58:04) CPU: Freescale i.MX6 family TO1.2 at 792 MHz Temperature: 36 C, calibration data 0x56a4bc7d mx6q pll1: 792MHz mx6q pll2: 528MHz mx6q pll3: 480MHz mx6q pll8: 50MHz ipg clock : 66000000Hz ipg per clock : 66000000Hz uart clock : 80000000Hz cspi clock : 60000000Hz ahb clock : 132000000Hz axi clock : 264000000Hz emi_slow clock: 132000000Hz ddr clock : 528000000Hz usdhc1 clock : 198000000Hz usdhc2 clock : 198000000Hz usdhc3 clock : 198000000Hz usdhc4 clock : 198000000Hz nfc clock : 24000000Hz Board: MX6Q-SABRELITE:[ POR] Boot Device: I2C I2C: ready DRAM: 1 GB MMC: FSL_USDHC: 0,FSL_USDHC: 1 JEDEC ID: 0xbf:0x25:0x41 Reading SPI NOR flash 0xc0000 [0x2000 bytes] -> ram 0x276009b8 SUCCESS *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: got MAC address from IIM: 00:19:b8:01:fd:6d FEC0 [PRIME] Hit any key to stop autoboot: 0 mmc1 is current device -- Trying fat on SD 1, partition 1 reading sel4-image 344564 bytes read ## Starting application at 0x20000000 ... ELF-loader started on CPU: ARM Ltd. Cortex-A9 r2p10 paddr=[20000000..2004c01f] ELF-loading image 'kernel' paddr=[10000000..10031fff] vaddr=[e0000000..e0031fff] virt_entry=e0000000 ELF-loading image 'hello-1' paddr=[10032000..1003ffff] vaddr=[8000..15fff] virt_entry=803c Enabling MMU and paging Jumping to kernel-image entry point... Bootstrapping kernel Caught cap fault in send phase at address 0x0 while trying to handle: vm fault on data at address 0x0 with status 0x7 in thread 0xffdfd900 "rootserver" at address 0x804 -- -Andrew Andrew P. Shruhan Research and Development Engineer III DocBox, Inc. 320 Nevada St Newton MA, 02460 Work: 857-598-2819 ext. 117 www.docboxmed.com http://www.docboxinc.com/