Hi Corey,
I will attempt to provide you with what answers I can, although I'm not the expert in this so Anna may say that all of this is wrong later
One important thing to consider for Real Time is not just the accuracy of the timer, but the Worst Case Execution Time of the kernel and any padding that needs to be given to timing estimates. The reason that the TSC deadline timer is used in the RT kernel is because it is both extremely cheap to read and, of all the timers, the cheapest to reprogram. This means that the kernel takes less time to perform timer ticks, and allows for a less pessimistic WCET analysis. Any potential error in timing, provided it is bounded, can also be added ass pessimism to the WCET. I have not done the maths to work out what gives less pessimism, the error of the TSC or the cost of a more accurate timer, but that is the pertinent question. This is why when we read the TSC in the kernel we just do 'rdtsc' and make no effort to serialize, the 'error' in doing so is much less than the cost of serializing and so results in less pessimism.
It is for similar reasons that the RT kernel goes away from tick based timing to tickless scheduling, although now precision does come into play. Clearly you now have a trade off between tick rate and deadline precision. Taking 'unnecessary' timer interrupts when operating at higher degrees of precision will again increase the pessimism of any scheduling analysis over what it would be with tickless scheduling. Nothing stops you from setting up a timer and counting ticks at user level though.
I mentioned on your github PR but will repeat here for the mailing list. The PIT is only used to measure the frequency of the TSC if we cannot pull the frequency directly out of the platform info MSR.
Adrian
On Sun 25-Dec-2016 12:21 PM, Corey Richardson wrote: Hi Anna,
While analyzing some time related APIs, I've noticed that the x86 rt kernel assumes that the tsc frequency is constant and well represented by the measurement made at init by comparing against the PIT. It also exposes only microseconds and uses the internal calibration to convert that to/from ticks. I'm concerned about this behavior. The tsc can have up to 200ppm error if uncalibrated and not temperature controlled, from what I'm able to determine. I'd rather have all the public APIs take ticks and allow user space to determine how their timing requirements best correspond to ticks. This came up when wanting to measure how much running time a process/thread has used. Ideally, it's kept as a running count of ticks. In the current API, one can only observe microseconds consumed, converted by a potentially lossy ticksToUs (lossy when the rate isn't exactly known or tick->us conversion isn't an exact integer multiplication). It'd be more useful for me to have tick count directly.
I'm also somewhat concerned with using the PIT to estimate the TSC rate, as I can't find anything about expected error of the PIT, and any slop there will influence all future kernel behaviors until reboot. One potential alternative is the ACPI PM timer or the HPET. Those run at higher frequencies, which would help reduce the error bounds on the rate estimation.
Let me know what you think! If it's useful at all, I've written up some stuff about the work that inspired these thoughts: https://gitlab.com/robigalia/meta/blob/master/blog/_drafts/2016-12-23-what-t...
Merry Christmas, -- cmr http://octayn.net/
_______________________________________________ Devel mailing list Devel@sel4.systemsmailto:Devel@sel4.systems https://sel4.systems/lists/listinfo/devel